 EmEditor (text editor) Forum Index EmEditor Core Enhancement Suggestions
selected characters/bytes | Register To Post |
| Threaded | Newest First | Previous Topic | Next Topic | Bottom |
| Poster | Thread |
|---|---|
| parameter | Posted on: 3/5/2012 12:26 pm |
Not too shy to talk   Joined: 3/5/2012 From: Posts: 30 |
selected characters/bytes It would be nice to see the number of characters or bytes for the current selection in the status bar. Maybe this text
17.2 KB (17,647 bytes), 502 lines. could change to (for example) 0.0 KB (70 bytes), 3 lines selected. when I've made a selection (and back to the other when I clear the selection). |
| Yutaka | Posted on: 3/6/2012 9:01 am |
Webmaster   Joined: 9/28/2006 From: Redmond Posts: 2404 |
Re: selected characters/bytes Hi parameter,
Did you check Customize > Status, and check "Number of Characters" and "Number of Lines"? Then you should be able to see the number of characters and lines only when selected. These numbers won't be displayed unless you select text. If you need to see the number of characters in the whole document, you can select all the document by pressing CTRL + A. Thank you,
|
| parameter | Posted on: 3/6/2012 10:17 am |
Not too shy to talk Joined: 3/5/2012 From: Posts: 30 |
Re: selected characters/bytes Thank you, I had not found that myself!
Yes, that's what I wanted. I have a tip for offering tips :) It took me a few minutes to figure out that Customize was on the tools menu. Maybe try including "Tools menu > [...]" on instructions. Like: Did you check Tools menu > Customize > Status, and check "Number of [...] Thanks again! |
| Threaded | Newest First | Previous Topic | Next Topic | Top |
| Register To Post | |